精品国产99久久久久久www_亚洲精彩视频在线观看的_性欧美婬妇ⅹxxx视频_里番肉工口全彩老师_a天堂最新在线观看_精品国产在天天在线观看_免费看那种视频_樱桃电视剧全集播放_成人性视频免费看的鲁片_中国伦理影院

General Description

DA9062 is a power management integrated circuit (PMIC) optimized for supplying systems with

single- and dual-core processors, I/O, DDR memory, and peripherals. It targets mobile devices,

medical equipment, IVI systems, and FPGA based applications.

DA9062 features four buck converters providing a total current of 8.5 A. High efficiency is achieved

over a wide load range with PFM mode available for low power or sleep modes. All power switches

are integrated, therefore, external Schottky diodes are not required. Furthermore, low-profile

inductors can be used with DA9062. Two of the buck converters can be used in a dual-phase

configuration, and one can be used as a DDR VTT supply. The four LDO regulators with

programmable output voltage provide up to 300 mA.

Dynamic voltage control (DVC) allows dynamic control of DA9062 supply voltages according to the

operating point of the system. It is controlled by writing directly to the registers using the I

2C

compatible 2-wire interface or the GPIOs.

DA9062 features a programmable power sequencer that handles start-up and shutdown sequences.

Power mode transitions can be triggered with software control, GPIOs, or with the on-key. Several

types of on-key presses can be detected to trigger different power mode transitions.

The real-time clock (RTC), with an external 32 kHz crystal oscillator, provides time keeping and alarm

functions. Additionally, the integrated watchdog timer monitors the system.

Five GPIOs are able to perform system functions, including: keypad supervision, application wakeup,

and timing-controlled external regulators/power switches or other ICs.

DA9062 is also available as an automotive AEC-Q100 Grade 2 version.

Key Features

■ Input voltage 2.8 V to 5.5 V

■ Four buck converters with dynamic voltage

control:

□ Buck1: 0.3 V to 1.57 V, 2.5 A

□ Buck2: 0.3 V to 1.57 V, 2.5 A

(can be used in dual-phase configuration

with Buck1)

□ Buck3: 0.8 V to 3.34 V, 2 A

□ Buck4: 0.53 V to 1.8 V, 1.5 A

(can be used as DDR VTT supply)

■ 3 MHz switching frequency

(enables low profile inductors)

■ Four LDO regulators:

□ LDO1: 0.9 V to 3.6 V, 100 mA

□ LDO2, LDO3, LDO4: 0.9 V to 3.6 V,

300 mA

■ Programmable power mode sequencer

■ System supply and junction temperature

monitoring

■ Watchdog timer

■ Five GPIOs

■ Coin cell/super-capacitor charger

■ Ultra-low power RTC with alarm

■ 32 kHz oscillator with external crystal

■ -40 °C to +125 °C junction temperature range

■ 40-pin QFN 6 mm × 6 mm package, 0.5 mm

pitch (exposed paddle)

■ Automotive AEC-Q100 Grade 2 version

available